Skip to content
Zipline Zipline Service Documentation

    Restart Flight Target

    published HW: EV2HW: EV3

    If needed, use the Stop Flight Target troubleshooting command to stop the flight target. For steps, see How to Use Troubleshooting Commands.

    When another mission is sent, the flight target will start.

    Restart Flight Target Using SSH

    Section titled “Restart Flight Target Using SSH”
    1. SSH into compute A or B depending on which side is impacted (SSH into Compute A/B). When in doubt, restart flight target on both computes.
    2. Run: sudo start-flight.

    Did this guide help you get unblocked?

    Open suggestions

    There are no open suggestions.

    Open pull requests

    There are no open pull requests.

    Edit this page on GitHub
    Topic history

    No topic history is available yet for this page.

    Suggest a change